Step 2: Connecting The Projector; Connecting To A Dvd Player/Recorder Or Digital Tuner - Sony VPL-VW100 Mode D'emploi

Step 2: Connecting the Projector

When making connections, be sure to do the following:
• Turn off all equipment before making any connections.
• Use the proper cables for each connection.
• Insert the cable plugs properly; plugs that are not fully inserted often
generate noise. When pulling out a cable, be sure to pull it out from the plug,
not the cable itself.
• Refer to the operating instructions of the connected equipment.

Connecting to a DVD Player/Recorder or Digital Tuner

To connect to a DVD player/recorder or digital tuner equipped with
component video connectors
Right side of the projector
S VIDEO
VIDEO
Y
: Video signal flow
Tip
To connect the projector to a DVD player/recorder, HDD recorder, digital tuner, etc.
which is not equipped with component video connectors, it is recommended to use the
S video cable to connect to the S-video output of the DVD player/recorder, HDD
recorder, digital tuner, etc. If the connected equipment is not equipped with the S-video
output connector, use the video cable to connect to the video output jack on the
equipment.
18
GB
Step 2: Connecting the Projector
INPUT
Y C /P C /P INPUT A
B B R R
C / C /P
B R R
P
B
Component video cable (not supplied)
Speakers
AV amplifier
DVD player/recorder, HDD
recorder, digital tuner, etc.,
with component video
connectors
P /
Y
B
C
B
P /
R
C
R