Caution Messages - Sony VPL-VW100 Mode D'emploi

Please replace the Lamp/
Filter.
End of Lamp/Filter life.
Lamp off in 1 min.
Please clean the filter.
Please clean the filter. Have
you finished? Yes V No v
Probably use in high
altitude. Switch to high
altitude mode on? Yes V
No v

Caution messages

Message
x
Not applicable!
Please check Network
Setting.
62
GB
Troubleshooting
c It is time to replace the lamp. Replace the lamp. (1 page 63)
c Also, replace the air filter too. (1 page 67)
If this message appears again after you replace the lamp and filter,
the lamp replacement process is not complete. Check the lamp
replacement process. (1 page 63)
c It is time to clean the air filter. Clean the air filter. (1 page 66)
c It is time to clean the air filter. Clean the air filter. (1 page 66)
c If you cleaned the air filter, select "Yes." If you did not clean the
air filter, select "No."
c When using the projector at an altitude of 1,500 m or higher:
select "Yes" to set to "High Altitude Mode". (1 page 52)
c If this message is displayed when using the projector at an
altitude of less than 1,500 m: check to see if nothing is blocking
the ventilation holes. (1 page 14)
Note
When you selected "Yes," the number of turns of the fan increases.
Cause and Remedy
c No signal is input in the selected input. Check connections. (1
page 18)
c Press the appropriate button.
c Invalid values, such as a blank, are entered in the
Network Setting window. Enter the correct values. (1 page 52)