On-Screen Display; Warning Indicators - Sony VPL-VW100 Mode D'emploi

The picture is not clear.
The fan is noisy.
The picture flickers.

On-screen display

Symptom
On-screen display does not
appear.
Remote control
Symptom
The remote control does
not work.

Warning Indicators

The LAMP/COVER or TEMP/FAN indicator lights up or flashes if there is
any trouble with your projector.
60
GB
Troubleshooting
c Adjust the focus. (1 pages 25 and 31)
c Condensation has accumulated on the lens. Leave the projector
for about two hours with the power on.
c Check the setting of "High Altitude Mode" in the Installation
menu. (1 page 52)
c Adjust "Dot Phase" for "Adjust Signal" in the Signal
properly. (1 page 47)
Cause and Remedy
c Set "Status" in the Setup
Cause and Remedy
c Batteries could be weak. Replace them with new batteries. (1
page 12)
c Insert the batteries with the correct polarities. (1 page 12)
c If there is a fluorescent lamp near the remote control detector,
the projector may work improperly or inadvertently. Change the
setting of "IR Receiver" in the Installation
51)
ON/ POWER
STANDBY SAVING
LAMP/COVER indicator
menu to "On." (1 page 53)
LAMP/ TEMP/
COVER FAN
TEMP/FAN indicator
menu
menu. (1 page