Table des Matières
Publicité
For dealers
When the projector is mounted on the ceiling, a
Sony bracket or recommended equivalent must
be used for installation.
Be sure to secure the cabinet cover firmly when
installing to the ceiling firmly.
Safety precautions for installing the unit on
a ceiling
Never mount the projector on the ceiling or
move it by yourself. Be sure to consult the store
where you purchased the projector or a
dedicated installer.
When installing the unit on a ceiling, be sure to
use a safety wire, etc., to prevent the unit from
falling. For the installation, be sure to consult the
store where you purchased the projector or a
dedicated installer.
On Installation
When installing the unit, leave space between
any walls, etc. and the unit as illustrated.
Top view
More than
50 cm
11
(19
/
")
16
Avoid using if the unit is tilted more than 15
degrees horizontally.
Avoid using the unit in a location where the
temperature or humidity is very high, or
temperature is very low.
28
GB
More than 50 cm
11
(19
/
")
16
More than
50 cm
11
(19
/
")
16
Avoid installing the unit in a location subject to
direct cool or warm air from an air-conditioner.
Installing in such a location may cause
malfunction of the unit due to moisture
condensation or rise in temperature.
Avoid installing the unit in a location near a heat
or smoke sensor. Installing in such a location
may cause malfunction of the sensor.
Avoid installing the unit in a very dusty or
extremely smoky environment. Otherwise, the
air filter will become obstructed, and this may
cause a malfunction of the unit or damage it.
When using the unit at an altitude of 1,500 m or
higher, set "High Altitude Mode" to "On" in the
Installation menu. Failing to set this mode when
using the unit at high altitudes could have
adverse effects, such as reducing the reliability
of certain components.
On cleaning the lens and the cabinet
Be sure to disconnect the AC power cord from
the AC outlet before cleaning.
If you rub on the unit with a stained cloth, the
cabinet may be scratched.
If the unit is exposed to volatile materials such as
insecticide, or the unit is in contact with a rubber
or vinyl resin product for a long period of time,
the unit may deteriorate or the coating may
come off.
Do not touch the lens with bare hands.
On cleaning the lens surface:
Wipe the lens gently-with a soft cloth, such as a
glass cleaning cloth. Stubborn stains may be
removed with a soft cloth lightly dampened with
water. Never use solvent such as alcohol,
Publicité
Chapitres
Table des Matières
