Step 1 Preparing; Checking The Supplied Accessories; Installing Batteries - Sony VPL-CWZ10 Manuel De Configuration

Step 1

Checking the Supplied Accessories

Remote Commander (RM-PJ8) (1)
Lithium battery (CR2025) (1)
The battery is already installed. Before using
the remote commander, remove the
insulation film.
AC power cord (1)
Mini D-sub 15 pin cable (1.8 m) (1)
(1-970-584-11/Sony)
Air filter cover (1)*
Dust cover assembly (1)*
Setup Guide (this manual) (1)
* For the customers in India only

Installing batteries

1
Pull out the lithium battery compartment.
Pull the battery compartment toward you
while releasing the lock.
2
Insert a lithium battery.
The lithium battery should be placed in the
compartment with the plus side facing up.
3
Close the lithium battery compartment.
36
GB
Preparing
Preparing
Attaching the Air Filter (For the Customers in
India only)
Note
Make sure to remove the protective cover on the unit
before attaching the air filter to the unit.
Protective cover
The supplied accessories required vary depending
on the installation method.
For installing to the floor
1
Remove the air filter from the dust cover
assembly, and then attach the air filter to the
air filter cover.
Dust cover assembly
Note
Pull the pull stick upwards when removing the air filter
from the dust cover assembly.
When attaching the air filter to the air filter cover,
make sure the correct side is being attached so that
the pull stick is protruding from the air filter.
Air filter
Pull stick
Air filter cover