Step 1 Preparing; Checking The Supplied Accessories; Inserting The Batteries Into The Remote Control - Sony VPL-XW7000 Manuel De Configuration

Step 1

Checking the Supplied Accessories

Check the carton to make sure it contains the
following items:
 Remote control RM-PJ24 (1)
 Size AA (R6) batteries (2)
 Lens cap (1)
When you purchase the projector, a lens cap is
on the lens.
 AC power cord (1)
 Setup Guide (this manual) (1)
Inserting the Batteries into the Remote
Control
Insert the batteries
Caution when handling the remote control
 Handle the remote control with care. Do not drop
it, and do not step on or spill liquids on it.
 Do not place the remote control in a location
near a heat source, a place subject to direct
sunlight, or a damp room.
Preparing
Push and slide to open.

side first.
Removing the Lens Cap
Remove the lens cap before you use the projector.
Notes on the lens cap
When removing the lens cap
When removing the lens cap, hold the parts other
than the catches and pull it toward you. If you pull
while holding the catches, the lens may be
damaged.
When attaching the lens cap
When attaching the lens cap, be sure to hook the
catches of the lens cap on the notches of the lens
to prevent it from falling out.
Note
The positions of the notches on the lens may differ from
the ones shown in the figure.
Catches
Notch
Catch
9
GB
Preparing