On-Screen Display; Remote Control - Sony VPL-HW55ES Mode D'emploi

Symptom
The picture flickers.
The color of characters or
the picture is not
appropriate.
Image is left on the screen.
(image retention)

On-screen display

Symptom
On-screen display does not
appear.
The model name does not
disappear from the screen.
Or else, the demo mode is
displayed continuously.
Input terminals do not
appear.

Remote control

Symptom
The remote control does
not work.
66
GB
Cause and Remedy
c For pictures from a computer, activate "APA" and adjust the
current input signal.
c Adjust "Phase" for "Adjust Signal" in the Screen
properly. (1 page 52)
c Select the desired color registration in "Panel Alignment" of
Installation menu (1 page 60).
c When High contrast non-moving images are displayed for a
long period of time, there may be some image retention on the
screen. This is only a temporary condition. Turning off the
power for a while will eliminate the retained image.
Cause and Remedy
c Set "Status" in the Setup
c Check if the ON/STANDBY indicator should light in green. The
ON/STANDBY indicator flashes while the projector is starting
up.
Avoid using the projector until the indicator light up in green.
c The display mode of the projector may be set at the time of
purchase. Consult with your local dealer or qualified Sony
personnel.
c Set "Auto Input Search" in the Function
page 57)
Cause and Remedy
c Batteries could be weak. Replace them with new batteries.
(1 page 11)
c Insert the batteries with the correct polarities. (1 page 11)
c If there is a fluorescent lamp near the remote control detector, the
projector may work improperly or inadvertently.
c Confirm the position of the remote control detector on the
projector. (1 page 8)
c If you use the optional 3D Sync Transmitter and point it to the
remote control detector of the unit, the remote control may not
work properly.
menu to "On." (1 page 53)
menu to "Off". (1
menu