Tips For Installation; Unsuitable Installation; Notes On Installation - Sony VPL-PX1 Mode D'emploi

Tips for Installation

Tips for Installation

Unsuitable Installation

Do not install the projector in the following situations.
These installations may cause malfunction or damage
to the projector.
Poorly ventilated
• Allow adequate air circulation to prevent internal
heat build-up. Do not place the unit on surfaces
(rugs, blankets, etc.) or near materials (curtains,
draperies) that may block the ventilation holes.
When the internal heat builds up due to the block-up,
the temperature sensor will function with the
message "High Temperature! Power off in 1 min."
The power will be turned off automatically after one
minute.
• Leave space of more than 30 cm (11
around the unit.
• Be careful that the ventilation holes may inhale
tininess such as a piece of paper.
Highly heated and humid
• Avoid installing the unit in a location where the
temperature or humidity is very high, or temperature
is very low.
• To avoid moisture condensation, do not install the
unit in a location where the temperature may rise
rapidly.
28
(GB)
Very dusty
Avoid installing the unit in a location where there is a
lot of dust; otherwise, the air filter will be obstructed.
The dust blocking the air through the filter may cause
raising the internal heat of the projector. Clean it up
periodically.

Notes on Installation

Carry out the followings.
No toppling of the unit
Avoid using as the unit topples over on its side. It may
cause malfunction.
7
/ inches)
8
Use to be level
Do not install the unit other than on the floor.
Do not adjust the height of the projector except the
use of the adjuster.
Avoid using as the unit tilts upward or downward.
These installation may cause malfunction.
No blocking the ventilation holes
Avoid using something to cover over the ventilation
holes; otherwise, the internal heat may build up.