The Set Setting Menu - Sony VPL-PX1 Mode D'emploi

Since the data is recalled from the preset memory
about the following signals, you can use these preset
data by adjusting SIZE. Make fine adjustment by
adjusting SHIFT.
Signal Memory No.
Super Mac-2 23
SGI-1 23
Macintosh 19" 25
Macintosh 21" 28
Sony News 36
PC-9821 36
1280 × 1024
WS Sunmicro 37
Note
When the aspect ratio of input signal is other than 4:3,
a part of the screen is displayed in black.

The SET SETTING Menu

The SET SETTING menu is used for changing the
settings of the projector.
S E T S E T T I N G
S T A T U S : O N
I N P U T – A : R G B
L A N G U A G E : E N G L I S H
S P E A K E R : O N
P OW E R S A V I N G : O F F
S I R C S R E C E I V E R : F R O N T & R E A R
Operation
1. Select an item
Use the M or m key to select the item, then press the
, or ENTER key.
2. Change the setting
Press the M or m key to change the setting.
To restore the original screen, press the ENTER or <
key.
SIZE
1312
1320
1328
1456
1708
1600
1664
I N P U T – A
The INPUT SETTING Menu / The SET SETTING Menu
STATUS (on-screen display)
Sets up the on-screen display.
ON: Shows all of the on-screen displays.
OFF: Turns off the on-screen displays except for the
menus, a message when turning off the power,
and warning messages.
For details on the warning messages, see page 27 (GB).
INPUT-A
Selects the RGB or component signal input from the
INPUT A connector.
Note
If the setting is not correct, "Please check INPUT-A in
SET SETTING." appears on the screen and the color
of the picture becomes strange or the picture is not
displayed.
LANGUAGE
Selects the language used in the menu and on-screen
displays.
Available languages are: English, French, German,
Italian, Spanish, Japanese and Chinese.
SPEAKER
Set to OFF to cut off the sound of the internal
speakers. When set to OFF, "SPEAKER OFF"
appears on the screen when you turn on the power.
POWER SAVING
When set to ON, the projector goes into the power
saving mode if no signal is input for 10 minutes.
SIRCS RECEIVER
Selects the remote control detectors (SIRCS receiver)
on the front and rear of the projector.
FRONT & REAR: Activates both the front and rear
detectors.
FRONT: Activates the front detector only.
REAR: Activates the rear detector only.
23
(GB)