Improper Use; Safety Precautions For Installing The Unit On A Ceiling - Sony VPL-HW55ES Mode D'emploi

Improper use

Do not do any of the following while using
the projector.
Blocking the ventilation holes (intake
or exhaust)
Ventilation holes
(exhaust)
Tip
For details on the location of the ventilation
holes (intake or exhaust), see "Location of
Controls" (1 page 8).
Tilting front/rear and left/right
15° or more
15° or more
14
GB
Ventilation holes
(intake)
15° or more
15° or more
Avoid using the projector tilted at an angle
of more than 15 degrees.
Do not install the projector anywhere other
than on a level surface or on the ceiling.
Installing the projector in such a location
may result in uneven color uniformity or
reduce the reliability of the effects of the
lamp.
If the projector is tilted up or down, the
image on the screen may be trapezoidal.
Position the projector so that the lens is
parallel to the screen (1 page 15).
When installing the unit at altitudes
When using the projector at an altitude of
1,500 m or higher, set "Cooling Setting" in the
Setup menu to "High" (1 page 53).
Failing to set this mode when using the
projector at high altitudes could have adverse
effects, such as reducing the reliability of
certain components.
WARNING
When installing the unit, incorporate a readily
accessible disconnect device in the fixed
wiring, or connect the power plug to an easily
accessible socket-outlet near the unit. If a fault
should occur during operation of the unit,
operate the disconnect device to switch the
power supply off, or disconnect the power
plug.
Safety precautions for
installing the unit on a ceiling
• Never mount the projector on the ceiling or
move it by yourself. Be sure to consult with
qualified Sony personnel (charged).
• When installing the unit on a ceiling, be sure
to use a safety wire, etc., to prevent the unit
from falling. Entrust the installation to an
experienced contractor or installer.
15° or more