Projecting; Projecting The Picture On The Screen - Sony VPL-GH10 Mode D'emploi

Projecting

This section describes how to operate the projector to view the picture from the equipment
connected to the projector. It also describes how to adjust the quality of the picture to suit
your taste.

Projecting the Picture on the Screen

DVI
Side panel of the
projector
Notes on input of a DVI-D signal
The projector adjusts the RGB dynamic range of the equipment connected with the DVI
cable to a Full (0-255) signal.
When a Limited (16-235) signal is input, the following symptom may occur.
• When a video signal is input, the color gradation of the dark area or bright area may
become unclear. In this case, switch the RGB dynamic range of the connected equipment to
If this adjustment is unavailable, adjust "Brightness" or "Contrast" in the
Full (0-255).
Picture menu of the projector. (1 pages 40 and 41)
26
GB
Power on both the projector and
the equipment connected to the
projector.
The DVI indication is displayed, and the
picture is projected on the screen.
To cut off the picture
temporarily
Press the PIC MUTING button on the side
panel of the projector. To restore the
picture, press the PIC MUTING button
again.