Operating The Projector From A Computer; Accessing The Projector From A Computer; Checking The Status Of The Projector - Sony VPL-GH10 Mode D'emploi

Operating the Projector from a
Computer
Accessing the
Projector from a
Computer
You can check the present status of the
projector on a computer display and control
the projector from a computer.
Confirm that the projector and computer are
connected to the router/hub with the LAN
cables, then turn on the projector, computer
and router/hub.
1
Start Internet Explorer 5.0 or
later version on your computer.
2
Type "http://xxx.xxx.xxx.xxx (the
IP address of the projector)" as
the "Address," then press the
ENTER key on a keyboard.
You can check the IP address of the
projector using the Installation
(1 page 51)
Enter the IP address here.
Tip
When "Standby Mode" in Setup
is set to "Standard 1", you can access the
projector from a computer even if the
projector is in standby mode.
Checking the Status
of the Projector
Click "Information." You can check the
information and present status of the
projector on a computer display. You can
check the information and status in the
window, but you cannot change the setting.
Information
The present status of the projector is
displayed.
Note
fH (horizontal frequency) and fV (vertical
frequency) may be displayed when
unacceptable signal is input.
Menu
The present settings of the projector are
displayed.
menu.
menu
53
GB