Step 2: Connecting The Projector; Connecting To A Computer - Sony VPL-GH10 Mode D'emploi

Step 2: Connecting the Projector

When making a connection, be sure to do the following:
• Turn off the projector and a computer before making a connection.
• Use the proper connecting cable.
• Insert the cable plugs properly; poor connection at the plugs may cause a malfunction or
poor picture quality. When pulling out a cable, be sure to pull it out from the plug, not
the cable itself.
• Refer to the operating instructions of the connected equipment.

Connecting to a Computer

Right side of the projector
TE
: Video signal flow
Note
If you set your computer, such as a notebook type, to output the signal to both computer's display
and this equipment, the picture of the equipment may not appear properly. Set your computer to
output the signal to only the external equipment.
For details, refer to the computer's operating instructions supplied with your computer. For settings
of the computer, consult with the manufacturer of the computer.
18
GB
DVI-D
DVI-DVI cable (not supplied)*
* We recommend use of a DVI-DVI cable with ferrite
cores.
to monitor output
Ferrite cores
Computer