Step 2: Connecting The Projector; Connecting With Video Equipment - Sony VPL-HS2 Mode D'emploi

Step 2:
Connecting the
Projector
When making connections, be sure to do the
following:
• Turn off all equipment before making any
connections.
• Use the proper cables for each connection.
• Insert the cable plugs properly; plugs that are not
fully inserted often generate noise. When pulling
out a cable, be sure to pull it out from the plug, not
the cable itself.
• Refer to the operating instructions of the connected
equipment.
• When you connect your projector to PJ MULTI,
select the input signal with the "Input-A Signal Sel."
setting in the SET SETTING
27)
10

Step 2: Connecting the Projector

GB
Connecting with Video
Equipment
menu. (1 page
output
S Video or
video/audio
cable (not
supplied)
to S
video
to S video/
or
video/
output
audio
Video equipment
Rear of the projector
with SONY
Signal
logo
interface
upside
cable
(supplied)
audio
Video equipment