Operations; Projecting The Picture - Sony KL-W7000 Mode D'emploi

Operations

Projecting the
picture
1
If the STANDBY indicator on the front of the
monitor is lit in orange, press POWER on the
remote control to turn on the power.
Press the power switch (green) on the monitor if the
STANDBY indicator is not lit.
The green u (power) indicator flashes, then lights
up.
12 -EN
Operations
LAMP STANDBY
Power switch
(green)
VOLUME
MENU
ENTER
INPUT SELECT
POWER
MUTING
DISPLAY
VIDEO RGB WIDE
CENTER/
MENU
SIZE
ENTER
VOL
POWER
2
Turn on the power of the connected
equipment.
3
Press RGB or VIDEO to select the input you
want to watch.
The selected input indication is displayed on the
screen.
To watch a computer picture input from the
RGB IN connector
Each time you press RGB, the display changes as
follows:
RGB 1 ˜ RGB 2
To watch a video picture input from the
VIDEO IN jacks
Each time your press VIDEO, the display changes
as follows:
VIDEO 1 n VIDEO 2 n VIDEO 3
VIDEO
You can also select the input by pressing INPUT
SELECT on the monitor.
Each time you press INPUT SELECT, the display
changes as follows:
RGB 1 n RGB 2 n VIDEO 1 n VIDEO 2 n VIDEO 3
INPUT SELECT
The input signal indication will automatically
disappear.
4
Press VOL +/– (VOLUME +/–) to adjust the
volume.
Remote control
VOL
RGB
Monitor
VOLUME
+
–