Sony VPL-VW100 Mode D'emploi page 30

2
Press the
The ON/STANDBY indicator flashes in green, and then lights in green.
3
Turn on the equipment connected to the projector.
Refer to the operating instructions of the connected equipment.
4
Press INPUT repeatedly to select the input you want to project
on the screen.
Display the indication of the input you want.
Example: To view the picture from the video equipment connected to the
To view the picture from
Video equipment connected to the VIDEO INPUT
connector
Video equipment connected to S VIDEO INPUT connector S-Video
Component equipment connected to Y/C
projector
RGB/component equipment connected to the INPUT A
connector
Video equipment connected to the DVI-D connector
Equipment connected to the HDMI connector
*Set the "Input-A Signal Sel." setting and "DVI Signal Sel." setting in the Setup
display the picture properly, select an appropriate signal according to the input
signal. (1 page 53)
Tip
When "Auto Input Search" is set to "On" in the Function
of the input signal is automatically displayed when you press INPUT.
30
GB
Projecting the Picture on the Screen
/ (on/standby) switch to turn on the projector.
? 1
VIDEO INPUT connector.
INPUT
menu according to the signal input. When you set it to "Auto," and cannot
ON/
Flashes in green for a few
STANDBY
seconds, and then lights in
green.
Video
/P /C /P on the
B B R R
Press INPUT to
display
Video
Component
Input-A*
DVI*
HDMI
menu, the channel