Connections And Preparations; Unpacking; Inserting The Batteries Into The Remote Control - Sony VPL-VW100 Mode D'emploi

Connections and Preparations

This section describes how to install the projector and screen, how to connect
the equipment from which you want to project the picture, etc.

Unpacking

Check the carton to make sure it contains the following items:
• Remote control (1) and
Size AA (R6) batteries (2)
• AC power cord (1)
• ImageDirector2 CD-ROM (1)
• Plug holder
Attach the plug holder to avoid
unplugging the AC power cord
accidentally.

Inserting the batteries into the remote control

12
GB
Unpacking
Insert the batteries E side first as shown in the illustration.
Inserting them forcibly or with the polarities reversed may cause
a short circuit and may generate heat.
• Air filter cover (1)
This air filter cover is used only when
the projector is installed on a ceiling.
(1 page 76)
• Lens cap (1)
When you have purchased the projector,
the lens cap was fitted onto the lens.
Remove this lens cap when you use the
projector.
• Operating Instructions (this manual) (1)