Connections And Preparations; Unpacking; Inserting The Batteries Into The Remote Control - Sony VPL-BW7 Mode D'emploi

Connections and Preparations

This section describes how to install the projector and screen, how to connect the
equipment from which you want to project the picture, etc.

Unpacking

Check the carton to make sure it contains the following items:
• Remote control (1) and
Size AA (R6) batteries (2)

Inserting the batteries into the remote control

Push and slide to open.
Caution about handling the remote control
• Handle the remote control with care. Do not drop or step on it, or spill liquid of any kind
onto it.
• Do not place the remote control in a location near a heat source, a place subject to direct
sunlight, or a damp room.
12
GB
• AC power cord (1)
• Lens cap (1)
When you have purchased the projector,
the lens cap was fitted onto the lens.
Remove this lens cap when you use the
projector.
• Signal cable (HD D-sub 15-pin y 3 ×
phono plug) (1)
(9-885-125-47, SONY)
• Operating Instructions (this manual)
• Warranty card (1)
Insert the batteries E side first as shown in the illustration.
Inserting them forcibly or with the polarities reversed may
cause a short circuit and may generate heat.