Installation Menu - Sony VPL-VW100 Mode D'emploi

Masquer les pouces Voir aussi pour VPL-VW100:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation Menu

The Installation menu is used for changing the installation settings.
Picture
Signal
Function
Installation
Setup
Information
V Keystone
Image Flip
Background
Lens Control
IR Receiver
Illumination
V Keystone :
0
Image Flip :
Off
Background :
Blue
Lens Control :
On
IR Receiver :
Front & Rear
Illumination :
On
High Altitude Mode : Off
Network Setting...
Sel:
Set:
Back:
Exit:
Corrects the vertical trapezoidal distortion of the picture.
When the bottom of the trapezoid is longer than the top (
Sets a lower value (– direction)
When the top of the trapezoid is longer than the bottom (
Sets a higher value (+ direction).
Note
Depending on the picture position adjusted with the lens shift
feature, the aspect ratio of the picture may change from the original
or picture distortion may occur with V Keystone adjustment.
Flips the picture on the screen horizontally and/or vertically.
Off: The picture does not flip.
HV: Flips the picture horizontally and vertically.
H: Flips the picture horizontally.
V: Flips the picture vertically.
Use this item for installation for the backside projection or ceiling
installation.
Selects the background color of the screen when no signal is
input.
You can set the background color in "Black" or "Blue."
Avoids any operation of the lens such as "Lens Focus," "Lens
Zoom," and "Lens Shift," by mistake.
When set to "On," you can adjust the projection lens using "Lens
Focus," "Lens Zoom," and "Lens Shift." After you make this
adjustment, it is recommended that you set this item to "Off" to
avoid any operation of the lens.
Selects the remote control detectors (IR Receiver) on the front
and rear of the projector.
Front & Rear: Activates both the front and rear detectors.
Front: Activates the front detector only.
Rear: Activates the rear detector only
Selects whether the illumination on the top panel of the
projector lights when the projector is on.
Turns on the illumination on the top panel of the projector, when set
to "On." It turns off when set to "Off."
):
):
51
Installation Menu
GB

Publicité

Table des Matières

Dépannage

loading

Table des Matières