Brewing Coffee With The Time Preselect - Unold 28736 Notice D'utilisation

18. During the brewing process the word, "Brewing", will be shown in the dis-
play.
19. You can remove the pot at any time during the brewing process. The drip
stop prevents residual coffee from dripping out of the filter. Put the pot back
under the filter within 30 seconds, so that the filter does not overflow.
20. When the appliance is finished brewing coffee, this is indicated by a signal
tone.
21. The warming plate remains switched on as long as the coffeemaker is
switched on, in order to keep the coffee remaining in the pot warm. After
35–40 minutes the appliance automatically switches off. If you do not want
the warming function, switch off the appliance with the „EIN/AUS", ("ON/
OFF") button.
22. After pouring out all of the coffee and emptying the pot completely, do not
place the empty coffee pot on the hot warming plate.
23. Remove the permanent filter and dispose of the coffee grounds.
The appliance becomes very hot during operation
and maintains the heat during some time after
disconnection.

BREWING COFFEE WITH THE TIME PRESELECT

1. The appliance is prepared as described in the chapter, "Brewing coffee".
ƒ In this regard, ensure that you set the coffee strength and the number of
cups as desired.
ƒ Decide whether you want to brew coffee from coffee powder or coffee beans
and if necessary press the „MÜHLE AUS". ("MILL OFF") button.
ƒ Please note that it is only possible to adjust the degree of grinding while
the appliance is grinding the beans. Ideally have the appliance brew coffee
without a a time preselect, and in this process, select the desired degree
of grinding. As soon as the appliance starts to grind the beans, you can set
the degree of grinding switch to the desired level. To prevent damage to the
grinder, do not change the degree of grinding if the appliance is not grind-
ing beans at the moment.
2. Check whether the time in the display agrees with the actual time. If it does
not, set the actual time as described in the chapter "Setting the time".
3. Press the "PROGRAM" button until the time shown in display flashes.
28
Copyright UNOLD AG | www.unold.de