Brewing Coffee With The Timer Function - Unold 28465 Notice D'utilisation

Masquer les pouces Voir aussi pour 28465:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
button "EIN/AUS" two times con-
secutively. The indicator lamp in
the button lights up blue for about
10 seconds. As soon as you press
the "EIN/AUS" button again, the
brewing cycle resumes.
12. You can also remove the pot to
pour coffee any time during the

BREWING COFFEE WITH THE TIMER FUNCTION

1.
First, make sure that the appli-
ance has been set to the correct
time; otherwise, the timer cannot
function correctly (chapter "Set-
ting the time").
2.
Prepare the appliance as descri-
bed in the section "Brewing Cof-
fee without the timer funktion",
step 1 - 7.
3.
Press the "PROG" button – the
current time is displayed.
4.
Press the "PROG" button again.
The display shows "Timer" at the
upper left.
Timer
15:00
5.
Now press the "STD" and "MIN"
buttons until the desired start
time for the brewing cycle is set.
After about 10 seconds with no
input, the appliance returns to the
initial setting.
6.
Then press the "PROG" but-
ton until the words "Clock" and
"Timer" no longer appear on the
display. The indicator lamp in
the "PROG" button lights up for
about 10 seconds and then goes
out again.
7.
Press the "EIN/AUS" button two
times consecutively. The indicator
24
brewing cycle. However, the pot
must be put back on the plate
within 30 seconds, since other-
wise the filter could overflow.
13. Remove the permanent filter and
dispose of the coffee grounds.
lamp in the button lights up blue
and blinks.
8.
If you wish to check the set time,
press the "PROG" button again.
The display shows "TIMER" and
the set time at the upper left. You
can now change the time if you
wish.
9.
When the set time is reached, the
brewing cycle begins.
10. When the brewing cycle is com-
plete, switch the appliance off by
pressing the "EIN/AUS" button
two times consecutively.
11. You can interrupt the brewing
cycle any time by pressing the
button "EIN/AUS" two times con-
secutively. The indicator lamp in
the button lights up blue for about
10 seconds. As soon as you press
the "EIN/AUS" button again, the
brewing cycle resumes.
12. You can also remove the pot to
pour coffee any time during the
brewing cycle. However, the pot
must be put back on the plate
within 30 seconds, since other-
wise the filter could overflow.
13. Remove the permanent filter and
dispose of the coffee grounds.

Publicité

Table des Matières
loading

Table des Matières