Associated Equipment; Transport And Storage; Equipment Compliance; Marking - Tractel Davitrac+ Manuel D'installation, D'emploi Et D'entretien

• Using Davitrac™+ if the safety function of any of the
associated items is affected by the safety function of
another item or may interfere with it.
• Performing any repairs or maintenance of Davitrac™+
without first having been trained and approved in
writing by Tractel .
®
• Using Davitrac™+ if it is not complete, if it has been
dismantled beforehand or if components have been
replaced by any party not approved by Tractel
• Attaching Davitrac™+ by any means other than as
described in this manual.
• Securing Davitrac™+ to a bearing structure with a
strength known to be or possibly below 16 kN.
• Using Davitrac™+ simultaneously as a fall arrest
anchor point and as a load lifting anchor point.
• Using Davitrac™+ with anchor brackets not approved
by Tractel.
• Using bases not approved by Tractel.
• Using Davitrac™+ with more than two anchor
brackets simultaneously.
• Using Davitrac™+ in the fall arrest configuration if the
space below the anchor device is incompatible with
the vertical clearance of the fall arrest system used or
if an obstacle is located in the fall path.
• Using Davitrac™+ if a rescue plan has not been
put in place beforehand in the event of a fall by the
operator.
• Installing a Tractel fall arrest anchor device on a
®
structure with a mechanical breaking strength below
16 kN vertically and horizontally. This load may be
applied vertically with a maximum lever arm of 27.5
in. (700 mm).

7. Associated equipment

• Fall arrest.
• Fall protection.
• Connector.
• Full body harness.
• Rescue lifting device.
• Anchoring bracket.
• Evacuation device.
Before using a fall arrest system, carry out the
regulatory checks in accordance with their specific
instructions for use
• Load lifting system SWL max. 1100lbs (500kg) in
accordance with ANSI.
• Tractel
anchor bracket
®
accordance with ANSI.
Before using a lifting system, refer to the specific
manuals of those products.

8. Transport and storage

Handle equipment with care, do not drop equipment
during loading or unloading. Take precaution's when
.
®
1100lbs (500kg) in
strapping for transport not to damage the equipment.
Impose loads on the skybeam
impact.
For associated systems, please refer to the specific
manuals of the associated products.
During storage and/or transport, the product must be:
• Stored at a temperature between -31°F to +140° F
(-35°C to +60°)
• Protected from chemical, mechanical or any other
type of attack.

9. Equipment compliance

Tractel hereby declares that the safety equipment
described in this manual,
Mounted floor, wall mounted, clearance mural, flush
floor bases and the self-stabilising base in combination
with the Davitrac™+ jib crane:
• meet the requirements and are conformed to the
ANSI and CSA applicable standards

10. Marking

The label marking of Davitrac™+ indicates (See page
8 - fig. 8)
a. Trade name: Tractel ,
®
b. Product description,
c. Reference standard followed by the year of application,
d. Product part no, e.g. 286819,
e. CE Logo followed by the number 0082, identification
number of the approved body responsible for
production inspection,
f. Date of manufacturing (YY/MM),
g. Serial number,
h. Pictogram showing that the manual must be read
before use,
o. Minimum breaking strength of the anchor device,
p. Number of individuals: 3 operators maximum,
w. Safe working load,
aa. Date of the next periodic inspection,
ae. Date of first commissioning,
af. Personal fall protection anchor device.

11. Periodic inspection and repair

An annual periodic inspection is mandatory; however,
depending on the frequency of use, environmental
conditions and regulations of the company or the
country of use, periodic inspections may be more
frequent.
If this equipment is dirty, wash it with plain cold water
and brush with a synthetic brush. During transport and
III gently and without
®
27
EN