Ppe And Rescue; Lifting; Description Of Systems Compatible With Davitrac - Tractel Davitrac+ Manuel D'installation, D'emploi Et D'entretien

There are 4 anchor points on the Davitrac™+. Three
anchor points (I) are designed for PPE use only (fall
arrest and rescue solution), the fourth (J) is designed
for material lifting and handling only. It is important that
EN
they only be used for there intended purpose. All four
anchor points are label-led for the intended use. (See
page 4 fig. 2).
Davitrac™+ has two pulleys on the anchoring head,
one of which is for use with PPE (I) and the other is
intended for lifting applications only (J). They may not
be used for PPE (See page 4 fig. 2).
Under no circumstances may the mounted floor, wall
mounted and clearance mural bases be used as fall
arrest anchor points when the Davitrac™+ jib crane
is installed inside one of them. It is imperative that
once the Davitrac™+ jib crane is installed and locked
into one of the mentioned permanent bases, the only
anchor points allowed are those on the Davitrac™+
jib crane.
When the Davitrac™+ jib crane is used in conjunction
with the Davitrac self-stabilising base:
• It is strictly forbidden to move a load suspended from
the Davitrac™+ jib crane outside the inside perimeter
of the self-stabilising base.
• The Davitrac™+ jib crane must not be rotated under
any circumstances with loads between 330 lbs (150
kg) and 1100 lbs (500 kg) (fig. 8a).
• The Davitrac™+ jib crane may only be rotated by
180° if the load is under 330 lbs (150 kg) (fig. 8b),
by temporarily removing the mast rotation locking rod
(P, fig. 2). Put back the mast rotation locking rod after
completing the operation.
• The angle of the load lifting cable from the upright
position should not exceed 1° for loads between 330
lbs (150 kg) and 1100 lbs (500 kg). (See fig. 9a.)
• The angle of the load lifting cable from the upright
position should not exceed 15° for loads under 330
lbs (150 kg) (fig. 9b).

4.3.1. PPE and rescue

Davitrac™+ is designed to receive brackets equipped
for rescue lifting devices and fall protection systems
that comply with the requirements of ANSI Z359.18-
2017 and CSA Z259.15-17.
No other assembly is permitted without the written
approval of Tractel
22
CAUTION
NOTICE
.
®
Davitrac™+ may be fitted with PPE anchor points,
rescue lifting devices and descender devices that
comply with the requirements of ANSI Z359.18-2017
and CSA Z259.15-17.

4.3.2. Lifting

WARNING
Davitrac™+ may be fitted with:
• hoists on brackets installed on its mast:
• Work winch SWL max 880 lbs (400 kg)
• hoists on the lifting anchor point on the head of
the boom:
• with feed-through cable, type Minifor
max. 1100lbs (500kg)
• with chain, type Tralift
(500kg)
NOTICE
No other assembly is permitted without the written
approval of Tractel .
®
CAUTION
The stated loads are the maximum values applicable,
which must not in any event be multiplied by the
number or anchor points located on the head or mast
of Davitrac™+.
WARNING
Davitrac™+ is not designed and intended for
platform suspension application.
4.4. Description of systems compatible
with Davitrac
WARNING
Before using the Davitrac™+, it is essential that the
supervisor and operator read and reviewed, and
understood the operating manuals of Davitrac™+ and
each associated accessory in the manuals provided
by Tractel . To ensure safe and effective use of the
®
equipment of the Davitrac™+ and related accessories.
All manuals related to the equipment being used must
be made available at all times to all operators.
, SWL
®
, SWL max. 1100lbs
®