DENTAURUM Orthocryl Mode D'emploi page 16

Instructions for use and safety information for the pressure
vessel should be adhered to strictly.
5. Finishing and polishing
Orthocryl acrylics can be finished and polished with the usual
®
mills and polishers. Protective equipment (face and eye protection)
should be worn.
6. Avoiding residual monomer and the
biocompatibility of Orthocryl
To reduce the amount of residual monomer, place the finished
appliance – if possible – in water for three days before being used
by the patient. This will reduce the amount of residual monomers to
similar values as for heat-curing acrylic. If this step is not possible,
advise the patient to place the appliance in water whenever it is
not being worn.
Orthocryl acrylics have undergone scientific testing. Information on
®
scientific testing and a detailed brochure of the entire Orthocryl
product range with many practical tips on processing is available
on request.
7. Information on cleaning and desinfection
Orthocryl acrylics can be cleaned with a tooth brush and tooth
®
paste. Please refer also to "Oral hygiene during orthodontic
treatment", REF 989-328-20.
Orthocryl acrylics can be disinfected with standard disinfecting
®
agents for impression materials (e.g. Impresept
Dürr Dental, Dentavon
Follow the manufacturer's instructions.
16
/ Schülke+Mayr or Mucalgin
®
acrylics
®
/ 3M Espe, MD 520 /
®
/ Merz Hygiene).
®
®