DENTAURUM Orthocryl Mode D'emploi page 14

3.2. Salt-and-pepper technique
Apply first a layer of powder (polymer), then a layer of fluid (monomer)
and continue applying alternate layers of polymer and monomer in
slight pendulum movements
Only apply as much fluid as the powder can soak up. The material
should not flow away.
To avoid the formation of air pockets under the screws, apply a
slightly larger amount of fluid to begin with so that the acrylic
spreads under the screws.
Finish application with a layer of powder. Apply enough powder so
that the top layer is dry. This ensures a precise fit and minimal shrink.
3.3. Doughing technique
Mix the Orthocryl
ratio of 2.5 : 1 (powder : fluid).
Allow to swell – Orthocryl
(possibly shorter if room temperature is high), then apply the acrylic
dough directly on the model.
3.4. Processing Orthocryl
Orthocryl fluids can be colored individually using the Orthocryl
®
color concentrates. We recommend a mixing ratio of 1 : 10 to 1 : 50
(color concentrate : Orthocryl
achieved with the dispensing pipette (REF 162-101-00).
Our recommendations for standard colors:
red 1 : 10
3.5. Processing Orthocryl
Orthocryl Disco glitter can be mixed with Orthocryl
®
intensity required. The amount of glitter used has no effect on the
14
/ Orthocryl EQ in a silicone mixing bowl at a
® ®
, 5 – 7 minutes, Orthocryl
®
color concentrates
®
fluid clear). Precise dosing can be
®
blue 1 : 50
Disco glitter
®
EQ 3 – 5 minutes
®
powder to the
®
®