Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
properties or the processing of Orthocryl
adding only a small amount of glitter, for example a small heap
on the end of a wax knife or a Le Cron instrument. Mixing ratio:
0.5 : 100 (glitter : powder).
3.6. Processing decals
Decals have a particularly striking effect when used with transparent
acrylic. The decals and the acrylic do not bind together chemically so
it is important to embed them completely in the acrylic.
3.7. Processing Orthocryl
The opaque coloring of Orthocryl
into consideration during processing. Orthocryl
decals lose their impact in opaque acrylic. In particular during the
finishing phase, avoid grinding the screws and wire elements. The
opacity of Orthocryl
Orthocryl
.
®
Mixing 50 % clear polymer with 50 % black or white polymer will
reduce the opacity so that wire elements, screws etc. become visible
in the Orthocryl
®
can also choose other mixing ratios to mix the polymers and to
obtain more or less opacity.
4. Time required for hardening / polymerization
Pressure vessel: 2.2 bar
Temperature:
Time: not less than 15 minutes (Orthocryl
not less than 20 minutes (Orthocryl
Do not interrupt polymerization in the pressure vessel during the
first 8 minutes (Orthocryl
the formation of micro bubbles caused by boiling.
black & white
®
black & white can be reduced by adding clear
®
, yet the acrylic will still appear black or white. You
40 – 46 °C / 104 – 114.8 °F
EQ) or 10 minutes (Orthocryl
®
. However, we recommend
®
black & white should be taken
®
®
EQ)
®
)
®
EN
Disco glitter and
) to prevent
®
15
Publicité
Table des Matières
