Use Of Detergent And Rinse Aid - ZANKER KDI 10000 Notice D'utilisation

Use of detergent and rinse aid

1 2 3
3 0
2 0
8
Use of detergent
To help the environment, do not use more than
the correct quantity of detergent.
Follow the detergent manufacturer recommendations
on the detergent packaging.
Do these steps to fill the detergent dispenser:
1.
Press the release button
the detergent dispenser.
2.
Put the detergent in the dispenser
3. If the washing programme has a prewash phase,
put a small quantity of detergent in the prewash
detergent compartment
4. If you use the detergent tablets, put the tablet in
the detergent dispenser
5. Close the detergent dispenser. Press the lid until it
locks into position.
Different brands of detergent dissolve in different
times. Some detergent tablets do not have the
best cleaning results during short washing pro-
grammes. Use long washing programmes when you
use the detergent tablets to fully remove the detergent.
Use of rinse aid
Rinse aid makes it possible to dry the dishes with-
out streaks and stains.
The rinse aid dispenser automatically adds rinse aid
during the last rinsing phase.
22
5
4
A
- +
6
7
8
2
to open the lid of
1
.
3
.
1
.
Do these steps to fill the rinse aid dispenser:
1.
To open the rinse aid dispenser, turn the cap
counterclockwise
2.
Fill the rinse aid dispenser
mark 'max' shows the maximum level.
3. Remove the spilled rinse aid with an absorbent
cloth to prevent too much foam during the washing
programme.
4. To close the rinse aid dispenser, put the cap in po-
sition and turn it clockwise.
Fill the rinse aid dispenser when the indicator
becomes clear.
Adjust the rinse aid dosage
Factory set: position 3.
You can set the rinse aid dosage between position 1
(lowest dosage) and position 4 (highest dosage).
Turn the rinse aid selector
the dosage.
Using combi detergent tablets
These tablets contain agents as detergent, rinse aid
and dishwasher salt. Some types of tablets can contain
other agents.
When you use tablets, that contain salt and rinse aid,
do not fill the salt container and rinse aid dispenser.
Be sure that these tablets are applicable for the water
hardness in your area (refer to the instructions on the
packaging of the products).
1. Adjust the water hardness to the lowest level. Refer
to 'Setting the water softener'.
2. Set the rinse aid dosage to the lowest position. Re-
fer to 'Use of detergent and rinse aid'.
Using again separately detergent, salt and rinse aid
1. Fill the salt container and the rinse aid dispenser.
2. Adjust the water hardness to the highest level.
3. Start a washing programme without dishes.
4. When the washing programme is completed, adjust
the water softener to the water hardness in your
area.
5. Adjust the quantity of rinse aid.
6
with rinse aid. The
7
to increase or decrease
4
5