Technical Data - ZANKER KDI 10000 Notice D'utilisation

The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Limescale particles on the dishes.
There are streaks, milky stains, or a
bluish layer on glasses and dishes.
Dry water drop stains on glasses
and dishes.
The dishes are wet.
The dishes are wet and dull.

Technical data

Dimensions
Water supply pressure
Possible cause
The selected washing programme
was not applicable for the type of
load and soil.
The baskets were not loaded cor-
rectly, water did not touch all surfa-
ces.
The spray arms could not turn free-
ly because of incorrect arrange-
ment of the load.
The filters are dirty or not assem-
bled and installed correctly.
The quantity of detergent was not
sufficient or missing.
The salt container is empty.
Incorrect water softener adjustment
The salt container cap is not closed
correctly.
Rinse aid dosage is too high.
Rinse aid dosage is too low.
The detergent can be the cause.
You have set a washing pro-
gramme without drying phase or
with a decreased drying phase.
The rinse aid dispenser is empty.
Width
Height
Depth
Minimum
Maximum
Possible solution
Make sure that the washing pro-
gramme is applicable for the type of
load and soil.
Load the baskets correctly.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
Make sure that the filters are clean
and correctly assembled and instal-
led.
Make sure that the quantity of de-
tergent is sufficient.
Fill the salt container with dishwash-
er salt.
Adjust the water softener.
Make sure that the salt container
cap is closed correctly.
Decrease the rinse aid dosage.
Increase the rinse aid dosage.
Use a different brand of detergent.
Let the door stay ajar for some mi-
nutes before you remove the
dishes.
Fill the rinse aid dispenser with
rinse aid.
0.5 bar (0.05 MPa)
8 bar (0.8 MPa)
596 mm
818-898 mm
575 mm
27