Setting And Starting A Washing Programme; Care And Cleaning - ZANKER KDI 10000 Notice D'utilisation

1

Setting and starting a washing programme

Select and start a washing programme
1. Close the door.
2. Select a washing programme. Refer to 'Washing
programmes'.
– The on/off indicator light comes on.
3. Press the start/cancel button. The washing pro-
gramme starts automatically.
– The start/cancel indicator light comes on.
Interruption of a washing programme
• Open the appliance door.
– The washing programme stops.
• Close the appliance door.
– The washing programme continues from the point
of interruption.
Cancelling the washing programme
If the washing programme has not started, you can
change the selection.
To change the selection while the washing programme
operates, it is necessary to cancel the programme.
• Press and hold the start/cancel button until the start/
cancel indicator goes off.

Care and cleaning

To remove and clean the filters
Dirty filters decrease the washing results.
24
2
Do these steps to move the upper basket to the higher
position:
1. Move the front runner stops (A) out.
2. Pull the basket out.
3. Put the basket in the higher or lower position.
4. Put back the front runner stops (A) in their initial
position.
Caution! If the basket is in the higher position, do
not put cups on the cup racks.
Make sure that there is detergent in the detergent
dispenser before you start a new washing pro-
gramme.
End of the washing programme
When the washing programme is completed, the end
indicator comes on.
Deactivate the appliance and open the appliance door.
For better drying results, keep the appliance door
ajar for some minutes.
Remove the items from the baskets
• Let the dishes become cold before you remove them
from the appliance. Hot dishes can be easily dam-
aged.
• First remove the items from the lower basket, then
from the upper basket.
• There can be water on the sides and on the door of
the appliance. Stainless steel becomes cool more
quickly than the dishes.