ZANKER KDI 10000 Notice D'utilisation page 26

Malfunction
The appliance does not fill with wa-
ter.
The appliance does not drain the
water.
The anti-flood device is on.
The start of the washing pro-
gramme does not occur.
After the check, turn the programme knob on the same
washing programme before the malfunction occurred.
The programme continues from the point of interrup-
tion.
If the malfunction occurs again, contact the service cen-
tre.
If the different alarm codes show, contact the service
centre.
26
Possible cause
The water tap is blocked or there is
limescale on it.
The water pressure is too low.
The water tap is closed.
The filter in the water inlet hose is
blocked.
The connection of the water inlet
hose is not correct.
The water inlet hose is damaged.
There is a blockage in the sink spi-
got.
The connection of the water drain
hose is not correct.
The water drain hose is damaged.
The appliance door is open.
You did not press the start/cancel
button.
The mains plug is not connected in
the mains socket.
The fuse in the fuse box is dam-
aged.
The necessary information for the service centre is on
the rating plate.
Record this information:
– Model (MOD.) ........................................................
– Product number (PNC) ..........................................
– Serial number (S.N.) ..............................................
Possible solution
Clean the water tap.
Contact your local water authority.
Open the water tap.
Clean the filter.
Make sure that the connection is
correct.
Make sure that the water inlet hose
has no damages.
Clean the sink spigot.
Make sure that the connection is
correct.
Make sure that the water drain
hose has no damages.
Close the water tap and contact the
service centre.
Close the appliance door.
Press the start/cancel button.
Connect the mains plug.
Replace the fuse.