Technical Information; Environment Concerns - ZANKER KDI10000XK Notice D'utilisation

After the checks are completed, turn the programme
knob until the programme marker is aligned with pro-
gramme that was in operation when the problem occur-
red. The programme continues from the point of inter-
ruption.
If the problem occurs again, contact the Service.
If other alarm codes show, contact the Service.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on glasses and
dishes
• The released quantity of rinse aid is too much. Ad-
just the rinse aid selector to a lower position.
• The quantity of detergent is too much.

Technical information

Dimensions
Electrical connection
Water supply pressure
1)
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot water supply to
decrease energy consumption.

Environment concerns

The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
24
Stains and dry water drops on glasses and dishes
• The released quantity of rinse aid is not sufficient.
• The quality of the detergent can be the cause.
Dishes are wet
• The programme is without a drying phase or with a
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Cold water or hot water
Place settings
Left-on mode
Off-mode
health, which could otherwise be caused by
inappropriate waste handling of this product. For more
detailed information about recycling of this product,
please contact your local council, your household waste
disposal service or the shop where you purchased the
product.
• Discard correctly the packaging material. Recycle
Adjust the rinse aid selector to a higher position.
low temperature drying phase.
Refer to 'HINTS AND TIPS' for other possible
causes.
2)
the materials with the symbol
596 / 818 - 898 / 570
220-240 V
50 Hz
(0.5 / 0.05 ) / (8 / 0.8 )
max. 60 °C
12
0.99 W
0.10 W
.