ZANKER KDI10000XK Notice D'utilisation page 20

2. Turn the programme knob until the programme
marker is aligned with the programme you want to
set. Make sure that the appliance is in setting
mode. Refer to 'SETTING AND STARTING A
PROGRAMME'. Set the correct programme for the
type of load and the degree of soil.
• If the salt indicator is on, fill the salt container.
3. Load the baskets.
4. Add the detergent.
5. Start the programme.
Using the detergent
1
A
3
Put the detergent or the
tablet in compartment
(A).
B
If the programme has a
prewash phase, put a
small quantity of deter-
gent in compartment (B).
20
2
A
4
Combi detergent tablets
These tablets contain detergent, rinse aid and other
added agents. Be sure that these tablets are applicable
to the water hardness in your area. Refer to the instruc-
tions on the packaging of the products.
When you use tablets, that contain salt and rinse aid,
do not fill the salt container and the rinse aid dispenser.
1. Adjust the water softener to the lowest level.
2. Set the rinse aid dispenser to the lowest position.
If you stop to use the combi detergent tablets,
before you start to use separately detergent, rinse
aid and dishwasher salt, do these steps:
1. Turn the programme knob until the programme
marker is aligned with the shortest programme with
a rinsing phase.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the rinse aid
dispenser are full.
4. Start the set programme, without detergent and
without dishes.
5. Adjust the water softener to the water hardness in
your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to start a
programme.
• Turn the programme knob until the programme
marker is aligned with a programme on the control
panel. If the on/off indicator comes on and the phase
indicators for the programme start to flash, the appli-
ance is in setting mode.
• Turn the programme knob until the programme
marker is aligned with a programme on the control
panel. If the on/off indicator and the start indicator
come on and a phase indicator is on with fixed light,
the appliance is not in setting mode.
To put the appliance in setting mode, press and hold
the start button until the start indicator goes off and the
phase indicators for the programme start to flash.
Starting a programme
1. Open the water tap.
2. Close the appliance door.