Care And Cleaning - ZANKER KDI10000XK Notice D'utilisation

• Make sure that cutlery and dishes do not bond to-
gether. Mix spoons with other cutlery.
• Make sure that glasses do not touch other glasses.
• Put the small items in the cutlery basket.
• Put the light items in the upper basket. Make sure
that they do not move.
• Make sure that the spray arms can move freely be-
fore you start a programme.
Before starting a programme
Make sure that:

Care and cleaning

Warning! Before maintenance, deactivate the
appliance and disconnect the mains plug from the
mains socket.
Dirty filters and clogged spray arms decrease the
washing results.
Make a check regularly and, if necessary, clean them.
Cleaning the filters
1
3
To remove filters (B) and
(C), turn the handle
counterclockwise and re-
move. Pull apart filter (B)
and (C). Wash the filters
with water.
22
C
B
A
2
A
4
Remove filter (A). Wash
the filter with water.
• The filters are clean and correctly installed.
• The spray arms are not clogged.
• The position of the items in the baskets is correct.
• The programme is applicable for the type of load and
for the degree of soil.
• The correct quantity of detergent is used.
• There is dishwasher salt and rinse aid (unless you
use combi detergent tablets).
• The cap of the salt container is tight.
D
A
5
Put filter (A) to its initial
position. Make sure that
it assembles correctly un-
der the two guides (D).
An incorrect position of the filters can cause bad
washing results and damage to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, remove re-
maining parts of soil with a thin pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abrasive prod-
ucts, abrasive cleaning pads or solvents.
6
Assemble filters (B) and
(C). Put them into posi-
tion in filter (A). Turn the
handle clockwise until it
locks.