Care And Cleaning - ZANKER ZKI1530 Notice D'utilisation

Setting and starting a washing programme with
delay start
1. Set a washing programme.
2. Press the delay start button.
– The delay start indicator light comes on.
3. Press the start/cancel button.
– The countdown of the delay start starts.
– The phase indicator lights go off.
When the countdown is completed, the washing pro-
gramme automatically starts.
• The delay start indicator light goes off.
• The phase indicator light comes on.
Do not open the door during the countdown to
prevent interruption of the countdown. When you
close the door again, the countdown continues from the
point of interruption.
Cancelling a delay start:
1. Press and hold the start/cancel button for approxi-
mately 5 seconds.
– The start/cancel indicator light and delay start
indicator light go off.

Care and cleaning

Warning! Switch the appliance off before you
clean the filters.
Cleaning the filters
Important! Do not use the appliance without the filters.
Make sure that the installation of the filters is correct.
Incorrect installation will cause unsatisfactory washing
results and damage to the appliance.
– The phase indicator lights start to flash.
2. Press the start/cancel button to start the washing
programme.
End of the washing programme
When the programme is completed, the end indicator
comes on. If you do not deactivate the appliance within
3 minutes, only the on/off indicator stays on. This helps
to decrease energy consumption.
1. Deactivate the appliance. Turn the programme
knob until the programme marker is aligned with
the on/off indicator.
2. Close the water tap.
For better drying results, keep the door ajar for some
minutes before you remove the dishes.
Let the dishes cool down before you remove them from
the appliance. Hot dishes are easily damaged.
Removing the load
• First remove items from the lower basket, then from
the upper basket.
• There can be water on the sides and door of the ap-
pliance. Stainless steel becomes cool more quickly
than the dishes.
1 2
Fully clean the filters A, B
and C below running wa-
ter.
27