Use Of Rinse Aid - ZANKER ZKI1530 Notice D'utilisation

5
It is normal that water overflows from the salt con-
tainer when you fill it with salt.

Use of rinse aid

Caution! Only use branded rinse aid for
dishwashers.
Do these steps to fill the rinse aid dispenser:
1
3
5
6
2
4
Fill when the rinse aid in-
dicator (B) becomes
clear.
Make sure that there is no grain of salt outer of
the salt compartment. Salt which stays on the
tank for a while drills the tank. It is recommended to
start a washing programme immediately after you fill
the salt container. This prevents of corrosion because
of spilled salt.
When you set electronically the water softener to level
1, the salt indicator light does not stay on.
Caution! Do not fill the rinse aid dispenser with
other products (e.g. dishwasher cleaning agent,
liquid detergent). This can cause damage to the ap-
pliance.
Adjusting the dosage of rinse aid
The rinse aid dial is set at
the factory at position 3.
To increase or decrease
the dosage refer to 'What
to do if...'
23