Grillo HWT 700 SUPERTRAC Manuel D'utilisation page 14

END OF SEASON MAINTENANCE
Thoroughly clean the machine, replace the engine oil (fig. 3, n. 13 – fig. 9, n. 22), clean the air filter
(fig. 3, n. 15).
PROCEDURE
Engine oil
Check the level
Replace
Check
Air filter
Replace
Check that the engine intake
grid is clean
Lubricate with grease
● recommended procedure
‫ ٭‬procedure to be carried out if necessary
GRASS-GUARD PROTECTION
This protections is recommended when cutting along streets and avenues to prevent the grass from
being thrown away (fig. 9). It can be mounted on the right side as well as on the left side of the
machine.
ANTI-SKID TOOTHED DISK KIT
These disks (fig. 10) can be mounted on the hub of the 3,50-8 wheels via the appropriate couplings
delivered with the kit. Combined with the wheels, this implement allows a greater grip on low-
adherence grounds and on slopes.
WARNINGS FOR TRANSPORT
Wheeled trimmers cannot be used on public roads. If the machine is to be transported on a lorry or a
trailer, lower the handlebar, engage the parking brake (fig. 2, n. 9), fasten the machine to the
lorry/trailer using ropes or belts. If a lifting machine is used to lift the wheels trimmers from the ground
into the lorry/trailer make sure its lifting capacity its suitable for the machine.
TRIMMER-Translation of the original instructions
MAINTENANCE SUMMARY TABLE
AFTER 20 EVERY 8
HOURS HOURS
●
IMPLEMENTS
12
EVERY 50 EVERY 100
HOURS
●
●
●
●
●
EVERY 200
HOURS HOURS
●
● ‫٭‬