Programming The Radio - Becker Centronic SunWindControl SWC545-II Notice De Montage Et D'utilisation

Assembly and Operating Instructions
1) Programming the master transmitter
a) Put receiver into programming mode
Note
Please refer to the operating instructions for the receiver.
• Switch off the receiver's power supply and reconnect after 5 seconds.
or
• Activate the "Programming" key or the radio-controlled receiver switch.
The receiver will then be in "Programming" mode for 3 minutes.
b) Programming master transmitter
When the receiver is in "Programming" mode, the programming button is to be
pressed until the receiver indicates that the programming process has been
successfully completed.
"SETTING SEND" appears.
Press OK to confirm.
The programming process is now complete.
2) Programming additional transmitters
a) Press the programming button of the master transmitter until acknowledge-
ment is given by the receiver.
"SETTING SEND" appears.
Press OK to confirm.
b) Now press the programming button of the new transmitter until acknowl-
edgement is given by the receiver.
c) Then press the programming button of the new transmitter to be learnt once
again.
The receiver will indicate when the programming process has been successfully
completed.
The maximum radio range is up to 25 m outside and inside the building and
up to 350 m in the open.
38
Programming the radio