Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TEST mode
The TEST mode is activated by adjusting the threshold value.
This mode will automatically end after approx. 15 minutes. Alternatively, the sliding
switch can be used to deactivate the test mode immediately.
In the TEST mode, the times for the sunshade function and wind control are re-
duced.
Sun threshold value:
Wind threshold value:
Programming the remote control
Caution
Before programming the transmitter, please check whether the threshold
control switches are set to the factory setting. When programming the
transmitter, ensure that you are not located in the operating area of the sun
protection system.
1) Learning the master transmitter
a) Put receiver into learn mode
Note
Please refer to the operating instructions for the receiver.
• Switch off the receiver's power supply and reconnect after 5 seconds.
or
• Activate the "Learn" key or the radio-controlled receiver switch.
The receiver will then be in "Learn" mode for 3 minutes.
b) Learn master transmitter
When the receiver is in "Learn" mode, the learn button is to be pressed until the
receiver indicates that the learn process has been successfully completed.
The learn process is now complete.
Factory setting
Intermediate position (25KLux)
Left limit stop (2 m/s) Intermediate position
16
Operating Instructions
Publicité
Table des Matières
