Explanation Of Functions; Programming The Remote Control - Becker Centronic EasyControl EC411 Notice De Montage Et D'utilisation

Channel
The channel of a hand-held transmitter can be programmed into one or more
receivers. One receiver is operated through an individual command, several
receivers through a group command.
Transmission pilot light
A radio signal is indicated by the transmission pilot light lighting up. The trans-
mission pilot light flashes while transmitting if the battery is getting weak. The
transmission strength and the radio range decrease as battery power de-
clines. If the transmission pilot light no longer lights up when a button is
pressed, the battery must be replaced.

Programming the remote control

1) Programming the master transmitter
a) Putting the receiver into programming mode
Follow the Assembly and Operating Instructions for the re-
ceiver.
•
Switch off the receiver power for 5 seconds, then switch it back on.
or
•
operate the programming button or the radio switch on the receiver.
The receiver is now in programming mode for 3 minutes.
b) Programming the master transmitter
Press the programming button on the master transmitter whilst in program-
ming mode until the receiver confirms that programming was successful.
The programming process is now complete.
14 - en

Explanation of functions