Becker Centronic SunWindControl SWC545-II Notice De Montage Et D'utilisation page 42

Assembly and Operating Instructions
SETTING
INTERMEDIATE POSITION, FABRIC TENSION/TILT, WINTER OFF/ON
INTERMEDIATE
POSITION
1. You have confirmed the menu items SUN t (DELAY t). INTERMEDIATE PO-
SITION appears.
2. The switching time for the INTERMEDIATE POSITION can be set using the
+/- buttons.
The switching time can be set in a matter of seconds. Alternatively, you can
move the shutter from the upper end position into the INTERMEDIATE POSI-
TION using the EXTEND/RETRACT buttons.
3. Press OK to confirm. FABRIC TENSION/TILT will appear.
4. The switching time for the FABRIC TENSION/TILT position can be set using
the +/- buttons. The switching time can be set in a few seconds. Alternatively,
you can move the shutter from the lower end position into the FABRIC TEN-
SION/TILT position using the EXTEND/RETRACT buttons.
Press OK to confirm.
5. You have confirmed the menu setting FABRIC TENSION/TILT. WINTER OFF/
ON appears.
6. Use the +/- button to switch the winter mode on or off.
Press OK to confirm your selection. The receiver acknowledges the selection.
Note
Manual extension should not occur, even if an extension control com-
mand is given. Check the setting.
7. The WINTER OFF/ON function is now set.
8. For further programming options in the SETTING menu refer to the next sec-
tion.
42
FABRIC TENSION/
TILT
WINTER
OFF/ON