Programming The Transmitter - Becker Centronic EasyControl EC5410-II Notice De Montage Et D'utilisation

Programming the transmitter

1) Programming the master transmitter
The central commands 1-5, 6-10 and 1-10 cannot be pro-
grammed separately.
a) Readying the receiver for programming
Follow the Assembly and Operating Instructions for the re-
ceiver.
Operate the programming button on the transmitter using a
suitable cylindrical tool (e.g. a ballpoint pen).
• Switch off the power supply to the receiver for 5 seconds, then switch it
back on
or
• Operate the programming button or the radio switch of the receiver.
The receiver is now in programming mode for 3 minutes.
b) Programming the master transmitter
Press the programming button on the master transmitter while in program-
ming mode until the receiver confirms that programming has been successful.
The programming process is now complete.
2) Programming additional transmitters
1. Press the programming button of the master transmitter until the re-
ceiver confirms.
2. Then press the programming button of the new transmitter until the re-
ceiver confirms.
3. Now press the programming button of the new transmitter again.
4. The receiver confirms successful programming.
18 - en