Basis Station - Eurochron EWM001 Notice D'emploi

The "TX" (26) button in the battery compartment serves to send out a data package with the measuring
data. This way, you can accelerate registration while the basis station performs its sensor search (e.g. for
a function test before installation).
The "RESET" (25) button resets the thermo/hygro sensor (alternatively, you can remove the batteries for
one minute and then insert it again).
• Put on the battery compartment lid again and attach it with the two small screws you removed at first. Do not use
any force for this.
At each transmission of the measuring data, the red LED (29) at the front of the thermo/hygro sensor will
flash briefly.
c) Basis Station
• Open the battery compartment on the back of the basis station.
• Insert two batteries of the type AAA/Micro with correct polarity into the battery compartment of the basis station
(observe plus/+ and minus/-).
• Right after inserting the batteries into the basis station, all display segments appear briefly, the display lighting is
switched on and a brief signal sound is emitted. The display lighting goes out again after a few seconds.
• The display shows the first measured values (indoor temperature/indoor humidity) and the symbol for the weather
forecast flashes at the top of the display. If this is not the case, briefly push the "RESET" button between the batter-
ies in the battery compartment with a pen.
• Close the battery compartment of the basis station.
• Set the current weather with the buttons "+/°C/°F" (6) and "-" (7).
Sunny
• Wait for a few seconds or briefly push the "MODE" (5) button. The symbol for the weather forecast will stop flashing.
• Now the basis station will start scanning for the radio signals of the wind sensor and the thermo/hygro sensor(s) for
3 minutes. The reception symbol "
Do not push any button on the basis station during this time.
Pushing the "TX" (26) button in the battery compartment of the thermo/hygro sensor or the small triangular
button (34) on the inside of the wind sensor will cause the respective sensor to send out a data package
with the measured data; this will accelerated and simplify recognition of the radio signals by the basis sta-
tion.
• When the reception symbol "
see the next chapter.
• If the display of the basis station is protected with a protective foil for transport, remove it now.
38
Slightly overcast
" will flash to the left of the temperature display.
" stops flashing, the basis station is ready. Now set, e.g., the time and the date;
Overcast Rain