Reely Supersonic Notice D'emploi page 52

Proceed as follows for programming:
• Switch on the transmitter if you haven't done it already.
• Switch off the speed controller ("OFF").
• Keep the setup button next to the on/off switch pressed and turn the speed controller on. The motor will emit a short
beep and both LEDs at the speed controller will flash briefly and simultaneously 1x. Continue to push and hold the
setup button. Don't release it.
• After approx. 3 seconds, the motor will emit two long sounds ("Di-Du") and both LEDs at the speed controller will
flash briefly and simultaneously 2x.
Now release the setup button. Then the speed controller will activate programming mode.
• Now the green LED will flash. The flashes of the green LED show which setting function (1...10) is currently se-
lected. Note the table on the following page.
• When the setting function that you want to change is displayed (e.g. function #8 = undervoltage protection, green
LED flashes 1x long + 3x short, the motor emits one long and 3 short beeps), briefly push the setup button.
• Now the red LED flashes and the motor emits beeps. The number of flashes of the red LED and the beeps indicate
which setting is active (e.g. function #3 = brake force, 1x flash/beep= 25%, 2x flash/beep = 50%, 3x flash/beep =
75%, 4x flash/beep = 100%).
• When the desired setting is displayed (by flashing of the red LED + beeping of the motor, e.g. function #3 = brake
force, 1x flash/beep = 25%), briefly push the setup button. The setting is now saved.
• The speed controller then returns to the function selection (this is displayed by flashing of the green LED and the
motor beeps).
You can now select another function (1....10) as described above and then change the respective settings.
• To end programming and save the settings, keep the setup button pushed for 3 seconds. The motor will emit two
long sounds ("Di-Du") and both LEDs will flash simultaneously 2x. The speed controller now saves all settings.
Then the motor will emit another long sound and both LEDs will flash simultaneously 1x. Saving is completed.
Now release the setup button.
• Switch off the speed controller and switch if on again after a few seconds. Now the speed controller can be used
with the newly programmed settings.
52