Commissioning; Remove Car Body; Installing The Receiver Aerial Cable; Inserting Batteries/Rechargeable Batteries In The Transmitter - Reely Supersonic Notice D'emploi

9.

Commissioning

a) Remove Car Body
Pull the safety clips out and take off the car body upwards.
b) Installing the Receiver Aerial Cable
Route the aerial cable through the enclosed aerial tube
and plug it into the corresponding holder next to the steer-
ing servo; see arrow in the figure on the right.
For a wide range, the aerial needs to protrude from the
vehicle as vertically as possible.
Ensure that the aerial cable is not damaged. Never short-
en the aerial cable! Never coil the aerial cable! This greatly
reduces the range!
c) Inserting Batteries/Rechargeable Batteries in the Transmitter
Open the transmitter's battery compartment and insert either batteries or fully charged rechargeable batteries. Ob-
serve correct polarity (plus/+ and minus/-), see label on the battery compartment. Close the battery compartment
again.
Observe the enclosed operating instructions for the remote control system.
d) Taking the Transmitter into Operation
Switch on the transmitter and put the trimming for steering and driving functions into the centre positions.
If the transmitter has a dual rate function, deactivate it or set it to unlimited steering deflection.
Observe the enclosed operating instructions for the remote control system.
45