Dogtra YS 600 Notice D'utilisation page 13

HOW TO USE THE ON/OFF & INTENSITY
DIAL
- he n Intensity Dial is used to turn the o ark Collar
on o and to select the stimulation intensity level.
- Set the dial to "." to turn o the o ark Collar.
- Set the dial to "P" or non-stimulating vibration only mode.
- he o ark Collar has stimulation levels 1 (lowest) through
10 (highest). Each stimulation level begins with a vibration and
is ollowed by the stimulation.
- Set the dial to " " to test the o ark Collar. See esting the
YS600 on page 25 to check i your unit is working properly.
On/Off & Intensity Dial
P
1~10
T
NOTICE
When rst using the YS600 o ark Collar, it is recommended
to start at the lowest stimulation intensity level. I your dog
continues to bark, gradually increase the stimulation intensity
level. Closely monitor you dog's reaction to nd the right
stimulation level or you dog.
22
Function
Power Off
Non-Stimulating Vibration
Stimulation Level
Test mode
THE LED INDICATOR
he LED indicator will ash or 1 second when the YS600
has been turned on, and every 4 seconds a terwards. I your
dog does not bark or over 30 seconds, the LED indicator will
turn o and the YS600 will go into a sleep mode to conserve
battery li e. It will reactivate when your dog barks and a
vibration correction needs to be made.
e ore going into Sleep mode, the LED light ashes green
when the battery is ully charged and turns to amber when the
battery li e is getting low.
When the LED indicator emits a blinking red light, the battery
needs to be recharged.
Battery life
Fully charged
LED window
On Working Green
On Charging Green
OPERATING MODES
1. Non-Stimulating High Performance Pager (P)
- he YS600 will vibrate twice when your dog barks. It will not
send a stimulation when set to "P".
2. Stimulation Intensity Levels (1-10)
- he YS600 will vibrate once ollowed by stimulation when
your dog barks.
* here is a 4 second delay between stimulation on levels
1-10 and vibration on P mode.
Medium charge Needs charge
Yellow Red
Red Red
23