Information On Electromagnetic Compatibility (Emc) - Erbe KAUTER N Mode D'emploi

11. Information on electromagnetic compatibility (EMC)

Where EMC is concerned, medical electrical equipment
is subject to special safety measures and must be installed
and commissioned according to the EMC instructions
stated herein.
ATTENTION!
The use of internal cables other than those specified in
the Service Manual may result in increased emissions or
decreased immunity of the equipment.
ATTENTION!
The equipment should not be used adjacent to or stacked
with equipment, other than with that which is intended
for this purpose. If adjacent or stacked use is necessary,
the entire system should be observed to verify normal
operation in the configuration in which it will be used.
Guidance and manufacturer's declaration - electromagnetic emissions
The equipment is intended for use in the electromagnetic environment specified below. The customer or the user of the
equipment should ensure that it is used in such an environment.
Emissions test
HF emissions CISPR 11
HF emissions CISPR 11
Harmonic emissions IEC 61000-3-2
Voltage fluctuations/flicker emissions
IEC 61000-3-3
Compliance
Group 1
Class B
Class A
Complies
Electromagnetic environment -
guidance
The equipment or system uses HF
energy only for its internal function.
Therefore its HF emissions are very
low and are not likely to cause any
interference in nearby electronic
equipment.
The equipment is suitable for use in all
establishments, including domestic
establishments and those directly
connected to the public low-voltage
power supply network that supplies
buildings used for domestic purposes.
17