Automatic Control - Kemper AirWatch Mode D'emploi

KEMPER AirWatch operating instructions - EN

5.5.1 Automatic control

Now, to enable automatic control of the CleanAirTower on the basis of instantaneous
measurements, go to the "Automation" section. Now, automation must be enabled by
checking the field "Control via AirWatch". You must then save the changes with the
"Accept" button. AirWatch now controls the CleanAirTower on the basis of the
instantaneous measurement.
However, this measurement must now be matched to the environment. The value set
by the works is more a dummy than a guideline value.
For setting the switching threshold, go to the AirWatch settings. Here, there is a
"Limits" sub-heading, via which you can then set the switching threshold for the
CleanAirTower - See diagram:
Part no.: 150 2608 - 62 - Rev.: 00
Issue: 03/2017
All rights over changes without prior notice and errors reserved.