Ethernet" Mode - Kemper AirWatch Mode D'emploi

KEMPER AirWatch operating instructions - EN
The AirWatch automatically lists all WLAN networks found in the vicinity and displays
these in a list as a dropdown menu (SSID field in figure X). Should the network you
want not appear in the listing, then the WLAN network is not compatible with the
AirWatch.
A manual entry, e.g. for a hidden WLAN is not possible at present. As a workaround,
in this case it suffices if you make the desired WLAN network visible in the short term
for the time of installation. If the configuration is set, you can hide the network again.

2.5 "Ethernet" mode

If you decide for cabled integration in an existing network, then you simply plug the
network cable into the socket provided for this purpose and select "Ethernet" mode
using the button shown in the following diagram.
Part no.: 150 2608 - 49 - Rev.: 00
Issue: 03/2017
All rights over changes without prior notice and errors reserved.