Kemper AirWatch Mode D'emploi page 45

− After a short waiting time (maximum one minute), the signal lights indicate start
sequence for the device by means of a fast sequence. Finally, the green signal
light indicates that the device is ready.
− The AirWatch now generates a separate WLAN access point - this is described
as "AirWatchAP".
− Now take a WLAN-enabled terminal device (smartphone in this example) and
switch to its WLAN- settings.
− The AirWatch access point should now be shown in the WLAN networks listing
. This is described as follows: "AirWatchAP" (in diagram marked red – iPhone
example).
Part no.: 150 2608
All rights over changes without prior notice and errors reserved.
KEMPER AirWatch operating instructions - EN
- 45 -
Issue: 03/2017
Rev.: 00