Error Rectification; Executing The Setup Assistant; Wifi/Wlan Mode - Kemper AirWatch Mode D'emploi

KEMPER AirWatch operating instructions - EN

2.2 Error rectification

If no message, note or window appears, then use an Internet browser and access the
following address:
http://192.168.48.1
The setup assistant now appears in the browser.
If problems persist, change the terminal device and, if possible, the browser (e.g.
when using a notebook or computer).

2.3 Executing the setup assistant

Now use the buttons (marked red in the diagram - heading 1) to select the
connection type:
− Select "WiFi/WLAN" to connect the AirWatch with an existing WiFi network.
− Choose "Ethernet" to connect the AirWatch with a cabled network.
− Choose "Access Point Mode", if you want your AirWatch to create its own access
point.

2.4 WiFi/WLAN mode

Using the input masks shown in the following diagram, you can select your desired
WLAN network and optionally set the corresponding password.
Part no.: 150 2608 - 48 - Rev.: 00
Issue: 03/2017
All rights over changes without prior notice and errors reserved.